Using Resistor network
Aim :
Convert four bits Digital signal to an analog equivalent signal using Resistor network.
Apparatus :
Multimeter, Dual power supply (15V), Op-Amp 741, resistors, Bread board, connecting wires.
Formula :
Circuit Diagram :
Procedure :
Circuit by – Rajendra Kumar
- Calculate the feedback resistance from the given formula for the maximum output voltage (10V).
- Connect the circuit as shown in the circuit diagram.
- Apply the input bit combination as per observation table and note down the output voltage.
- Repeat step-2 fall all entries mentioned in observation table.
- At the end, compare the observed output voltage with theoretically calculated output voltage.
- Plot a graph of output voltage against decimal number.
Obs/Cal/Graph/Result :
Viva Question and Answers [FAQ] :
1. What is Resistor network?
Ans : A resistor network is a combination of several resistors that are configured into a pattern.
2. Which power supply use in Resistor network Experiment?
Ans : DC power supply.